Description:
PAM8403 small digital amplifier chip, high-definition sound to
highlight the advantages of digital chips, circuit surrounding the
most reasonable configuration, power supply filtering is upgraded
to 470uf (some sellers do not even have to 100uf not
capacitive)1.6mm glass plate, the real amplifier board did most
detailed output 3W + 3W high-fidelity sound, the amplifier is a
rare good product enthusiasts, the potential use of original
anti-meter body, life expectancy up to 15 years, with switch
potentiometer can be directly counter-clockwise off the power,
listing has been well received by buyers praise!Feature:
Model:PA8403
Power:Low Power
Super size:29.5 * 20.2 * 15mm (excluding protruding potentiometer
lever)
Excellent noise suppression, in the absence of circumstances
connected to input audio ear close to the speaker can not hear any
noise, two-channel stereo, 5V power supply can output 3W 3W power,
can directly drive 4Ω, 8Ω small speakers, the output power large,
full of energy, good sound quality. The unique non-LC filter
Class-D digital power board can be directly used computer USB power
supply. Double panel wiring, wiring properly resolve the ground
potential caused by balance and inter-channel
crosstalk,ultra-miniature design, can easily be placed in a variety
of digital products within a small space, high amplification
efficiency.All using the whole plate welding machine, welding
quality comparable non-manual soldering iron!
Customer common problems:
1, 2 * 3 w miniature digital power amplifier board class D power
supply can use the computer?
Answer:power amplifier board can use a computer power supply, but
will produce noise may be produced (also some customers did not
appear murmurs), the best advice of independent power supply.
2, miniature digital 2 * 3 w class D power amplifier boards with
the speaker of the house is good?
Answer:our speaker is only provide DIY players try, sound is not
particularly good, if the pursuit of high sound client can buy
separately.3, 2 * 3 w miniature digital power amplifier board class
D why there are noise after power on the speaker?
The answer:
1.appear whistlers, should be the audio input line, the
introduction of shielded wire should be used for audio input line,
and
then there is audio input line don't hung up to connect good audio
source.
2.is a kind of reason may be that some power supply is bad
interference is very big,switch power supply.
Good noise suppression,under the condition of the connected input
audio, ears also can't hear any noise on the speaker, dual channel
stereo, 5 v power supply can output 3 w+3 w power, can be directly
driven 4 Ω, 8 Ω small speakers, big output power,energy, sound
quality is good. Unique without LC filter class D digital power
board, can use computer USB power supply directly.
Double panel wiring, properly solve wiring caused by potential
balance and crosstalk between channels, super mini design, can be
easily placed in a variety of digital products within a small
space, high amplification efficiency. Are all made of solid plate
welding machine, welding quality of the manual soldering iron
welding comparable!
Note:
The left and right channel output of the "negative" and can not be
connected together,otherwise it will burn IC,and should be preceded
powered speakers connected (load).
Rated working voltage 2.5V ~ 5V, limit operating voltage 5.5V.