Rugged sealed constraction Alunimum case Waterproof Ultrasonic Transducer transmitter and receiver sensor 25mm 40khz

TEST CIRCUIT

ENVIRONMENTAL CHARACTERISTICS

1. Sound pressure level and sensitivity shall not change by more than 15dB in temperature range of -20°C

to 60°C, at a relative humidity of 30%.

2. Sound pressure level and sensitivity shall not change by more than 6dB in the humidity of 10% to 90%, at

the temperature of 25° .

3. MOISTURE

Keep the sensor at 40°C±2°C and 90°C to 95°C R.H for 96±4 hours. Then, release the sensor into the room conditions for 24 hour prior to the measurement. It shall fulfill the specifications in Table 1.

4. VIBRATION

Subject the sensor to the vibration for 1 hour each in the X.Y and Z axes with the amplitude of 1.5mm

at 10 to 55 Hz. It shall fulfill the specifications in Table 1.

5. HIGH TEMPERATURE EXPOSURE

Subject the sensor to 80±5°C for 24± 1 hours. then, release the sensor into the room conditions for 1 hour prior to the measurement. It shall meet the specifications in Table 1.

4.6 LOW TEMPERATURE EXPOSURE

Subject the sensor to -30±5°C for 24± 1 hours. Then release the sensor into the room conditions for 1 hour prior to the measurement. It shall meet the specifications in Table 1.

TABLE 1

NOTES

1.This sensor is designed for use in air. Do not use this sensor in fluid.

2.In case where this sensor is to be hold in housing, use soft buffer between sensor and housing. The front

part of this sensor vibrates in large.

If this part is hold, its characteristics will vary. The top must be free to vibrate.

3. To prevent sensor malfunctions, operational failure or any deterioration of its characteristics, do not use this sensor in the following, or similar conditions.

A. In strong shock or vibration.

B . In high temperature and humidity for a long time.

C. In corrosive gases or sea breeze .

D. In an atmosphere of organic solvents. E. In dirty and dusty environments that may contaminate the sensor front.

IMPEDANCE/PHASE ANGLE vs FREQUENCY

Tested under 1Vrms Oscillation Level

ECHO SENSITIVITY

Tested under 10Vrms @30cm

BEAM ANGLE

Tested at 40.0khz frequency

NOTICE

1.Export Control <For customers outside The People's Republic of China>

No Manorshi products should be used or sold, through any channels, for use in the design, development, production, utilization, maintenance or operation of, or otherwise contribution to

( 1) any weapons (Weapons of Mass Destruction [nuclear, chemical or biological weapons or missiles] or conventional weapons) or

(2)goods or systems specially designed or intended for military end-use or utilization by militar end-uSers.

2. Please contact our sales representatives or product engineers before using the products ir the specification or cataloque for the applications listed below, which require especially high reliability for the prevention of defects which might directly damage a third party's life, body or property, or when one of our products is intended for use in applications other than those specified in this specification.

a) Aircraft equipment or Aerospace equipment

b) Undersea equipment and Power plant equipment

c) Medical equipment and Transportation equipment (vehicles, trains, ships, etc.) d)Traffic signal equipment i Disaster prevention / crime prevention equipment

e) Data-processing equipment including Application of similar complexity and/or reliability requirements to the applications listed above

3. Product specifications and catalogues are subiect to change and our products in them ma be discontinued without advance notice.

Please check with our sales representatives or product engineers before ordering. If there are any questions, please contact our sales representatives or product engineers.

4. Please read rating and CAUTION (for storage, operating, rating, soldering, mounting and handling) in this specifications in order to prevent smoking and/or burning, etc.

5. Please note that unless otherwise specified,we shall assume no responsibility whatsoever for any conflict or dispute that may occur in connection with the effect of our and/or a third party's intellectual property rights and other related rights in consideration of your use of our products and/or information described or contained in our specifications and cataloques.In thi connection, no representation shall be made to the effect that any third parties are authorized to use the rights mentioned above under licenses without our consent.

6. No ozone depleting substances(ODS)under the Montreal Protocol are used in our manufacturing process.

PACKING

• Specializing in this field for 20 years.Please connect us get more details:

Email:sales88@taimihk.com

Mobile/whatsApp:+86 13538467125

TaiMi Electronics Technology Co.,ltd.Specialize in manufacturing & exporting of electronic Components,Pressure sensor,Flow senosr,Piezo ceramic,transduucer,,and Ultrasonic Sensors of the finest quality.We are presently catering to Automotive,Defence, White Goods,Telecom,smart home,Robotics,model airplanes,Communications Industry.We have strong ability in designing new products as per customer's specification by full sets of tooling equipment and advanced test equipment,And professional RD team. We have been expanding our market in US,Europe,Middle East,and Southeast Asia.We have built impectable reputation and business relations with our customers all over the world. "Forever sincerity, practice and business prosperity" is our service concept.We hope to cooperate with all overseas partners.Let's do it better.