DLY5-2A DLY5-5A DLY5-10A Electromagnetic Disc Brake Retarder

DLY5 Series Electromagnetic Brake Retarder Electromagnetic Disc Brake

Products Introduction

Dly5 (Eze Series) jaw type electromagnetic clutch with slip ring

Dly5 (Eze Series) tooth embedded slip ring electromagnetic clutch is an actuator used in mechanical transmission system to combine or separate the driving side part and the driven side part of rotary motion with the help of electromagnetic force, so as to realize power and motion transmission

The standard operating voltage of the clutch is 24 volts DC In general, it is easy to realize automatic and remote control by using a simple circuit composed of switches, buttons, contactors, travel switches and other ordinary electrical components, so as to meet the requirements of speed change, commutation, starting and positioning of mechanical transmission system.

This series of clutches transmit torque by means of the engagement of fine teeth on the end face. Therefore, compared with the friction plate clutch of the same specification, it has small volume, no friction and heating, complete separation after power failure, no no no-load torque, and can be suitable for both wet and dry work. The clutch is rigidly combined. It can only be combined under the condition of low speed. It is suitable if it is at rest or when the relative speed is synchronous.

The clutch can work reliably under the following conditions:

1. The ambient air temperature is - 5 ℃ - + 40 ℃.

2. In the medium without explosion hazard, and there is no gas and conductive dust sufficient to corrode metal and damage insulation in the medium.

3. The clutch shall work under the condition of lubricating oil.

4. The voltage fluctuation of clutch coil shall not exceed + 5% and - 15% of rated voltage.

5. The altitude of the clutch installation site shall not exceed 2000 meters.

Products Parameters

Installation:

1.The clutch can be installed either in horizontal or in verial,If it mounted no the alex,

he coaxlal degree between the driving and the driven shaft should not exceed 0.05mm,

and must ensure the work clearence value σ.

2.The teeth of both ends should be cleaned before mounting the clutch.

3.The driving and the driven parts of the clutch must be fixed in axial direction,its axial moving doesn't permitted.

Changzhou Tianniu Transmission Equipment Co., Ltd is a professional one way clutch bearing supplier, the primary products are micro electromagnetic clutch, torque limiter coupling, sliding shaft coupling, flexible propeller shaft coupling, locking assembly and shaft couplings, etc.

We have been in shaft coulpling and clutch one way bearing industry for more than 10 years, persisting in the business principle of products tailored to requirements from clients. We service through listening to our customers, applying innovation and building with craftsmanship to meet all their needs.

Our Products

Full range of shaft coupling products supply

We have been in Sprag Clutch Bearing and clutch one way bearing industry for more than 10 years, persisting in the business principle of products tailored to requirements from clients. We service through listening to our customers, applying innovation and building with craftsmanship to meet all their needs.

With a wide range, good quality, reasonable prices, stylish design and accepting OEM, our products are extensively used in mining machine equipment, convey equipment, reducer and many other industries.With well equipped testing facilities and strict quality control, Changzhou TIANNIU Transmission Equipment Co., Ltd's products sell well all over the world, the main markets are European, America, Canada, Brazil, India, Asia, etc . It was a certified enterprise with Quality Management System ISO9001:2015, SGS , Safety Certificate of Approval for Mining Products.

Exhibitions

Open to customers from all over the world

We welcome clients from all over the world to seek help from us and we look forward to becoming your long-term and stable shaft coupling manufacturer in China.