Stainless Steel Air Terminal Lightning Arrester , ESE Lightning Conductor For Chimney

HD series lightning rod is based on the traditional Franklin type lightning rod, according to GB 50057-2010 and IEC 61024 standard design and development of high-quality lightning catcher. According to the appearance and production process is divided into HD-P ordinary single needle series, HD-Y optimization lightning rod series, HD-T early discharge lightning rod series and HD-Z decorative lightning rod, flash catcher made of special stainless steel materials, waterproof, anti-corrosion, anti-fouling; novel structure, beautiful and generous, easy to install, long service life.

It can be used for direct lightning protection in a wide variety of buildings, open public areas, broadcast and communication equipment, and facilities such as beacon lights and towers.

Installation, use and maintenance
Lightning rod should be installed on the pole tower, tower or other buildings, set up in accordance with the protection requirements, raise the height of the pole tower or tower.
Lightning rod installation and testing shall not be carried out in a thunderstorm
Lightning rod grounding device available two round steel or flat steel in 180 ° direction at one end and the pole tower foot or tower foot welding, the other end and daughter wall lightning belt reliable welding; or separate lead down and independent grounding network reliable welding.
Regularly check (once a year) lightning rod each connection screw, weld is solid, grounding lead wire and grounding system connection is reliable. If you find that the connection screws, welds are corroded severely, we must replace the screws to reconnect, the original weld to make up.