WDG Line 15kw Pharmaceutical Fluid Bed Dryer

high quality horizontal type fluidizing bed drying for WDG line

Description

high quality horizontal type fluidizing bed drying for WDG line is also called fluid bed. Through operation and improvement over 30 years, it has play an active part in the fields of pharmaceutical, chemical, foodstuff, gain and so on industries. It consists of air filter, fluid bed, cyclone separator, dust collector, high-speed centrifugal fan, control cabinet and so on. Because of the difference of property from raw material, it is necessary to equip dust remover in accordance with practical needs. It may select cyclone separator and dust collector both or one of them. In general, cyclone separator can be selected if the raw material is larger and the dust collector may be selected if the raw material is light. Moreover, there is pneumatic feeding device for your selection. There are two kinds of operation for this machine, continuous and intermittent type.

sketch flow for model A sketch flow for model B(inner bag type) sketch flow for model C

(bag filter A manul,B pluse)

Application

Drying process of medicines, chemical raw material, foodstuff, grain processing, feed and so on. For example, raw medicine, tablet, Chinese medicine, foodstuff of health protection, drinks, feed, resin, citric acid and other powders. The suitable diameter of raw material is normally 0.1-0.6mm. The most applicable diameter of raw material will be 0.5-3mm.

Working principle

The clean and hot air enters into fluid bed through distributor of valve plate. The wet material is fed from the feeder forms the fluid state by hot air. Because of the wide contact between hot air and raw materials, the time of drying is short. If use continuous type, the material enters from the front of bed, fluidized in bed for several minutes, and float another side of bed. The machine’ works in negative pressure.

Technical Parameters

NOTE: The drying capacity is measured on the basis of the primary and final moisture contents of 20% and 5% respectively of drying plum crystal and air intake temperature at 130 ℃.drying capacity for other material will be based on the practical drying condition.