RJ45 lightning arrester signal ethernet spd ethernet surge protector

Telephone and Network Signal surge protective device Terminal pc network card and telephone signal lightni

Model:Trss-rj11 / 45

colour: white

Authentication:CE ECM

Brief introduction

The TRSS-RJ45/8 type network lightning arrester is a lightning protection measure taken by Zhejiang tohr Electric Co., Ltd. to independently develop and manufacture the network system.
According to the characteristics of the network system, we choose the high quality and low capacitance gas discharge tube, TVS and other devices. It has the advantages of small insertion loss, quick response speed, accurate clamping, low output pressure and so on. The effect of electromagnetic interference is small, the transmission is not affected, and it can be used in peace at any time.

Product features

1. multi-functional overvoltage protection, lightning and overpressure are no longer afraid of disasters.
2. the speed of response is 0.001 seconds, and the voltage is controlled in the range that the equipment can withstand.
3. low output residual pressure to further ensure safety
4. high transmission, low loss, high transmission frequency and low attenuation coefficient, ensure that the lightning arrester does not affect the system performance.

Product specification

1. Rated Operating Voltage(UN):12v

2. Max continuous operating voltage(UC):15V

3. Voltage protective level(UP):<60V

4. Max discharge current(IMAX):5KA

5. Nominal discharge current(IN):3KA

6. Response time(NS): ≤1

7. Adaptive date transfer rate: 100Mbps

8. Insertion loss: ≤0.3dB

Working principle of product

In the process of equipment operation, if there is abnormal voltage, the network arrester will play a protective role. When the protected device is running under normal working voltage, the arrester will not work, and it will be regarded as a circuit for the ground. Once the high voltage is present and the insulation of the protected equipment is endangered, the lightning arrester acts immediately and leads the high voltage impact current to the earth, thus limiting the amplitude of the voltage and protecting the insulation of the electrical equipment. When the overvoltage is gone, the arrester is restored to its original state quickly, so that the system can supply electricity normally. The main function of the lightning arrester is to reduce the voltage value of the protected equipment through the action of parallel discharge gap or nonlinear resistance, and to reduce the voltage value of the protected equipment, so as to protect the power equipment.

Use of attention

1. the standard RJ45 interface can be conveniently connected to the front end of the protected device, and the grounding path should be as short as possible, and the length should not exceed 1.5 meters.

2. when installing, pay attention to cables coming in and out of surge protective devices, so as to avoid the two coupling of surge.

3. the protected equipment must have good grounding, and the grounding impedance is in accordance with the relevant national standards.

4. After correct installation, it can work steadily for a long time. If it is found that the transmission performance of the system is reduced or the signal is interrupted due to the cause of surge protection, it should be maintained or replaced in time.

5. please recognize the interface and connection mode.

Product packaging:Carton packing

Transportation method

2. Trains, ships, aircraft transport

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.

Incorporated in 2006, Zhejiang Thor Electric Co., Ltd has built everything to offer a wide range of innovative and reliable surge protection solutions and products.

Thor is following the international quality system standards, is ISO 9001 certified and our technical standards are in line with GB18802.1-2011/IEC61643-1.

All types and classes of our lightning and surge arresters 20KA~200KA(8/20μS) and 15KA~50KA(10/350μS) are tested and pass all the requirements based on their class.

Thor has been designing new products to meet the RoHS directive since 2006. Thor’s ongoing commitment to RoHS compliance includes continuing efforts to reduce the presence of hazardous substances in the design and manufacture of a growing number of popular products.

Zhejiang Thor Electric Co., Ltd is committed to meeting the requirements of the European Union’s Waste Electrical and Electronic Equipment (WEEE) directive. This directive requires producers of electrical and electronic equipment to finance the take-back for re-use or recycling of their products placed on the EU market after 2005.