AC90V~AC264V Solar Power Automatic Barrier Gate Boom Gates 2 Year Warranty

Solar Power 2 Year Warranty Automatic Barrier Gate Boom Gates

Automatic Barrier Gate Functions:

1. The Automatic Barrier Gate automatically opens when the power is off, with no clutch design, and no need for human intervention. When the power is on, the Automatic Barrier Gate automatically reset, and the Automatic Barrier Gate returns to being closed, truly unattended, according to fire safety standards. If there is a special need, manual operation is required when the power is off, the operating arm can open and close manually. Can also set up the control board DIP switch, which will ensure the system can be used at any time

2. The use of a Single Compression Balance Spring device, good regulation, no noise, indefatigable, not easily broken, safe, and reliable.

3. A variety of input and output modes can be selected, normally open normally closed are optional.

4. The arm opening angle can be adjusted from 60 to 90 degrees, 10 degrees resolution, suitable for eaves prominent place to install.

5. Automatic Barrier Gate Speed can be adjusted.

Automatic Barrier Gate Data sheet

​

Program 1

The Automatic Barrier Gate can be controlled by a two-key push button and an impulse will trigger the operation relay.

Connecting GND and COM, 24V with UP is for machine opening, and 24V with Down is for machine closing. Other accessory interface inputs, like IR sensor and loop detector signal, are available.

Program 2

The Automatic Barrier Gate can be controlled by remote controller or GSM gate opener.

Connecting the antenna receiver GND to COM on the board, Remote-up is for opening and Remote-down is for closing.

If the remote control receiver is a non-electric relay signal, connect GND and COM first. The 24V connecting with Remote-up opens, and the 24V connecting with Remote-down closes.

Program 3

TheAutomatic Barrier Gate can be controlled by gate photocell(IR sensor) or loop detector for automatic opening and closing. There are other signal inputs as emergency stop and alarm signals. The connection is as Program 1 mentioned.

Program 4

Automatic Barrier Gate Boom-drop signal input: when the boom is crashed by a passing vehicle, the Automatic Barrier Gate will stop to run with a warning output.

Contact us for pricelist and catalog:

Sue Zhang
Email:sue@wonsunbarrier.com
Skype: SueZhang729
Whatsapp:+86 158 7925 9831