Silicone Potting Compound Machine Adhesive Dispensing Equipment for Potting Solutions

1. Automatic material-feeding system
2. High precision pump metering system
3. Dynamic/Static mixing system
4. Three-axis motion system
5. Programming control system.

3)Features&Functions:

1. Auto feeding : take use of vacuum pressure to feed materials into A&B tank separately.
2. Tank Stirring : A and B tank configure with stirring motors and blades to prevent material sediment in the tank bottom .
3. Heating : Tank , pipe , pumps are optional with heaters to assure the whole system can be heating from room temperature to 90°C adjustable.
4. Vacuum : A &B tank vacuum for degas the bubble inside material .
5. Dynamic mixing : Configuring dynamic motor and mixer to mix A and B fluids evenly.

6)Electronic Appliances

Common troubles and solutions

• 1.Glue dispenser always drops

  Drops always happened when valve closed . The reason may be low concentration of glue , big air-pressure or large diameter of needles.

  Narrow needles will effect the flow of the liquid and cause back pressure . It will lead to dropping when the valve closed . Too narrow needles will effect the drainage of air when valve start to work, but it can be solved if change suitable needles .

  Conical needles with less back pressure and liquid flow smoothly .

  It is better to drainage of the air advance or use no-foam glue or deaeration to avoid the air cause dropping after valve closed .

• 2.Glue dispensing not evenly

  The problem cause mainly because of the storage flow pressure tank or air pressure is not stable.

  Inlet pressure regulating table should be set lower 10-15psi than factory minimum pressure . The pressure in pressure tank should be set upper than the middle pressure of regulating table . It should be avoided to use the pressure lower than the middle pressure of regulating table .

  Control pressure of rubber valve at least higher than 60psi to assured glue evenly .

  We should check the glue output speed at last . The glue is uneven if the time less than 15/1000s , the output speed more longer , the glue dispensing will be more stable .

• 3.Slow flow velocity

  It should be changed the pipe from 1/4 to 3/8 if the flow velocity too slowly .

  The pipe is the shorter the better if no requirement .

• 4.Air in the fluid

  Excessive fluid pressure and short valve opening time may lead to the air infiltration liquid . We can use the conical needles and reduce fluid pressure .

• 5. Instant glue (quick adhesive) blocking in valve connector and pipes.

  This problem is caused by heavy moisture and recycle instant glue . We should make sure to use new instant glue and wash the pipes with dry . Make sure air dry and add filter between plant air pressure and valve .

• 6.UV glue (UV curing glue )

  Make sure to use black pipeline.

  Don't add new UV glue to old UV glue in pressure tank , we should drain off the old UV glue before pouring new UV glue into pressure tank because the UV glue will produce bubble after a period of time and lead to glue dispensing unevenly .

• 7.Needles

  Normally , it may cause air problem if the needle less than NO.20 . It is better to use large steel needles or conical needles to avoid to use winding needles or teflon needles

• 8. Epoxy cleaning

  It is better to use storage pressure cylinder of methybenzene toluene to self-cleaning one time for each shift . The more frequently cleaning the better .